Skip to main content
YSTRAL Jet Stream Mixers

YSTRAL TDS Induction Mixers

Low-dust induction, suspension and dissolution of powders in liquids

YSTRAL TDS-Induction Mixer

Low-dust induction, suspension and dissolution of powders in liquids

TDS Induction Mixers draw powder, liquids or gases below their level into liquids and at the same time homogenise the contents of the container.
The vacuum required for induction is generated in the mixing head.
The machine is installed in the container from above by means of a flange or traverse. Alternatively, the TDS Induction Mixer can work on a lifting frame.

Advantages of the YSTRAL TDS Induction Mixer

  • Dust-free induction of powder in liquids, mixing and dispersion with a single machine
  • Dust loads are prevented during the addition of powder by direct induction from the bag
  • Effective micro and macro mixing of the complete container contents with simultaneous addition of powder
  • Immediate wetting under fluid level
  • Complete mass transfer and homogeneity across all container levels via the jetstream mixing principle
  • In addition, liquids and gases can be inducted
  • Prevention of product adhesion to the container wall or built-in components

Functionality of the YSTRAL TDS Induction Mixer

  • The powder is inducted from the container and introduced under the fluid level by mixing it immediately and wetting.
  • The mixing head generates the required negative pressure (suction vacuum).

Technical data

Power: 5.5 – 25 kW
Speed: 1.500 / 3.000 min-1 stepless up to 3,600 min-1 with frequency converter
Seal: Lip seal, mechanical seal single or double depending on application condition
Options: Explosion-resistant design, certificate, qualifications
diving part: Stainless steel 1.4404 (AISI 316 L), special material
Bearing flange: Aluminium-coated, stainless steel 1.4404 (AISI 316 L)
Power: 5.5 – 25 kW
Speed: 1.500 / 3.000 min-1 stepless up to 3,600 min-1 with frequency converter
Seal: Lip seal, mechanical seal single or double depending on application condition
Options: Explosion-resistant design, certificate, qualifications
diving part: Stainless steel 1.4404 (AISI 316 L), special material
Bearing flange: Aluminium-coated, stainless steel 1.4404 (AISI 316 L)

Downloads

Contact

Or contact us via: